The 700PBC flush grid plastic belt curve conveyor is engineered for conveying products through curved paths at defined angles, such as 30, 45, 60, or 90 degrees. Its flush grid belt provides airflow and drainage through the belt surface while maintaining product support, making it suitable for turns in packing or assembly lines.
This curve configuration helps maintain orientation and control of conveyed items when routing around equipment or facility obstacles, supporting efficient layout design.
Applications
- Product transport through packaging lines
- Accumulation and buffering between processes
- Inclined conveying of cartons or components
- Curved routing around equipment
- Handling of small parts, containers, and packaged goods
Industries
- Food and beverage processing
- Packaging and labeling
- Manufacturing and assembly
- Plastics and molded products
- Pharmaceutical and personal care
- Distribution and material handling
SPECIFICATIONS
| BELTING | Series 2200 flush grid gray curved polypropylene belt, FDA and USDA approved |
| DRIVE SPROCKETS | 5.3 in. pitch dia. with 1.5 in. square bore. Optional 6.3 in. or 7.7 in. pitch dia. sprockets with 1.5 in. or 2.5 in. square bore |
| TAIL SPROCKETS | 5.3 in. pitch dia. with 1.5 in. square bore. Optional 6.3 in. or 7.7 in. pitch dia. sprockets with 1.5 in. or 2.5 in. square bore |
| END DRIVE | Allows one-direction operation only; conveyor is not reversible |
| BEARINGS | Precision heavy duty lubricated ball bearing units with cast iron housings |
| BED / FRAME | 7 in. x 1-1/2 in. x 10 ga. formed steel channel frame with UHMW wearstrips attached to bed and belt return pan |
| TAKE-UP | Catenary type located at discharge end |
| MINIMUM RADIUS | 2.2 x belt width measured from inside edge of belt |
| TANGENTS | Minimum 1.5 x belt width at each end; minimum 3 ft at discharge end required, 5 ft recommended. Optional additional tangent at discharge |
| BELT SPEED | 60 FPM constant |
| FLOOR SUPPORT | Optional |
| DIRECTION OF FLOW | Specify right hand or left hand |
| MOTOR DRIVE | 1/2 HP, 230/460/3, 60 cycle, Super "E" right angle gear motor |
| ROLLER CHAIN | Drive shaft driven by No. 50 roller chain |
| ELECTRICAL CONTROLS | Optional |
DETAILS
ACCESORIES / OPTIONS
Floor Supports
Ceiling Hangers
Guard Rails
Belt Speed
Motors
Controls
WARRANTY
Electrical: 12 Months
Mechanical: 12 Months
SERVICES
Technical Support
Installation & Service
Preventative & Routine Maintenance
Application Support
Operator & Maintenance Training
